LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2006 >> IS 250 RWD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Automatic Transmission) >> Automatic Transmission System >> DTC P0756 Shift Solenoid "B" Performance (Shift Solenoid Valve S2) >> Typical Enabling Conditions

Typical Enabling Conditions

WARNING: This page is about a different car, the 2006 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.

The following items are common to all conditions below. 

TYPICAL ENABLING CONDITIONS

The monitor will run whenever this DTC is not present. P0115 - P0118 (ECT sensor)
P0125 (Insufficient ECT for Closed Loop)
P0500 (VSS)
P0748 - P0798 (Trans solenoid (range))
Turbine speed sensor circuit Not circuit malfunction
Output speed sensor circuit Not circuit malfunction
Shift solenoid valve S1 circuit Not circuit malfunction
Shift solenoid valve S2 circuit Not circuit malfunction
Shift solenoid valve S3 circuit Not circuit malfunction
Shift solenoid valve S4 circuit Not circuit malfunction
Shift solenoid valve SR circuit Not circuit malfunction
Shift solenoid valve SL1 circuit Not circuit malfunction
Shift solenoid valve SL2 circuit Not circuit malfunction
ECT (Engine coolant temperature) sensor circuit Not circuit malfunction
KCS sensor circuit Not circuit malfunction
ETCS (Electric throttle control system) Not system down
Transmission range "D"
ECT 40°C (104°F) or more
Spark advance from Max. retard timing by KCS control 0°CA or more
Engine Starting

OFF malfunction (A) 

TYPICAL ENABLING CONDITIONS

ECM selected gear 1st
Vehicle speed 1.2 mph (2 km/h) or more
and
less than 24.9 mph (40 km/h)
Engine speed - Turbine speed (NE - NT) 150 rpm or more

OFF malfunction (B) 

TYPICAL ENABLING CONDITIONS

ECM selected gear 6th
Vehicle speed 1.2 mph (2 km/h) or more
Throttle valve opening angle 6.5% or more at 2,000 rpm
(Conditions vary with engine speed)

ON malfunction (A) 

TYPICAL ENABLING CONDITIONS

ECM selected gear 5th
Vehicle speed 1.2 mph (2 km/h) or more
Throttle valve opening angle 6.5% or more at 2,000 rpm
(Conditions vary with engine speed)

ON malfunction (B) 

TYPICAL ENABLING CONDITIONS

ECM selected gear 6th
Vehicle speed 1.2 mph (2 km/h) or more
Throttle valve opening angle 6.5% or more at 2,000 rpm
(Conditions vary with engine speed)