LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2006 >> IS 250 RWD, Standard >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat >> Rear Seat Assembly >> Installation

Rear Seat Assembly: Installation

  1. INSTALL REAR SEATBACK ASSEMBLY 
    1. Place the seatback in the cabin.
      NOTE: Be careful not to damage the vehicle body.
    2. Install the seatback with the 4 bolts.

      Torque: 18 N*m (184 kgf*cm, 13 ft.*lbf) 

    3. Pass the 3 seat belts through and close the cap of the 2 rear seat shoulder belt guides.
    4. Install the floor anchor part with the bolt.
    Fig 1: Identifying Seatback With 4 Bolts
    G04051224Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL REAR CENTER SEAT HEADREST ASSEMBLY 
  3. INSTALL REAR SEAT HEADREST ASSEMBLY 
  4. INSTALL REAR SEAT CUSHION ASSEMBLY 
    1. Attach the 2 rear hooks of the seat cushion to the seatback.
    2. Attach the 2 front hooks of the seat cushion to the vehicle body.
    3. Confirm that the seat cushion is firmly installed.
      NOTE: When installing the seat cushion, make sure the seat belt buckle is not under the seat cushion.
    Fig 2: Attaching Rear Hooks Of Seat Cushion To Seatback
    G04051225Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals