Drive Belt: Installation

INSTALL V-RIBBED BELT
1. Install the V-ribbed belt.
2. While turning the belt tensioner counterclockwise, remove the bar.
  
  Fig 1: Identifying Belt Tensioner
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  NOTE:
  - Put the backside of the V-ribbed belt on the tensioner pulley and idler pulley.
  - Check that the V-ribbed belt is properly set to each pulley.
3. If it is difficult to install the V-ribbed belt, perform the following procedure.
  1. Put the V-ribbed belt on every part except the tensioner pulley.
  2. While releasing the belt tension by turning the belt tensioner counterclockwise, put the V-ribbed belt on the tensioner pulley.
    
    Fig 2: Identifying V-Ribbed Drive Belt Routing
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    NOTE:
    Put the backside of the V-ribbed belt on the tensioner pulley and idler pulley.
    
    Check that the V-ribbed belt is properly set to each pulley.
INSTALL V-BANK COVER SUB-ASSEMBLY (See Step 115 in INSTALLATION )
INSTALL NO. 1 INLET AIR CLEANER (See Step 87 in INSTALLATION )
INSTALL COOL AIR INTAKE DUCT SEAL (See Step 118 in INSTALLATION )