On-Vehicle Inspection

1. Check the operation.

1. Using a speedometer tester (calibrated chassis dynamometer), check the speedometer indication according to the table below.

   Reference: mph (U.S.A.) 

   CHASSIS DYNAMOMETER INDICATION REFERENCE
   
   

   Chassis dynamometer indication	Acceptable range
   20 mph	20.0 to 23.0 mph
   40 mph	40.0 to 43.5 mph
   60 mph	60.0 to 64.0 mph
   80 mph	80.0 to 84.5 mph
   100 mph	100.0 to 105.0 mph
   120 mph	120.0 to 125.5 mph
   140 mph	140.0 to 146.0 mph

   Reference: km/h (Canada) 

   CHASSIS DYNAMOMETER INDICATION REFERENCE
   
   

   Chassis dynamometer indication	Acceptable range Data in ( ) is for reference
   20 km/h	(17.5 to 21.5 km/h)
   40 km/h	38.0 to 42.0 km/h
   60 km/h	58.0 to 63.0 km/h
   80 km/h	78.0 to 84.0 km/h
   100 km/h	98.5 to 104.5 km/h
   120 km/h	119.0 to 125.0 km/h
   140 km/h	139.0 to 146.0 km/h
   160 km/h	159.0 to 167.0 km/h
   180 km/h	179.0 to 188.0 km/h
   200 km/h	199.0 to 209.0 km/h
   220 km/h	219.0 to 230.0 km/h
   240 km/h	239.0 to 251.0 km/h

   NOTE: Tire wear as well as over or under inflation will cause errors.
2. Check the deviation from the acceptable range of the speedometer indication.

   Reference: 

   Less than 0.5 km/h (0.3 mph) 

HINT:

If the indication is not as specified, go to PROBLEM SYMPTOMS TABLE  .

1. Connect a tune-up tachometer, and start the engine.
2. Compare the test results with the tachometer indications.

DC 13.5 V, at 25°C (77°F) 

HINT:

If the indication is not as specified, go to the PROBLEM SYMPTOMS TABLE  .

1. Disconnect the connector from the engine oil pressure switch.
2. Engine switch on (IG).
3. Ground the terminal of the wire harness side connector, then check the low oil pressure warning light.

   OK: 

   Oil pressure warning light comes on. 

   HINT:

   If the warning message is not displayed, go to the PROBLEM SYMPTOMS TABLE  .

1. Disconnect the engine oil level sensor connector.
2. Engine switch on (IG), and check the multi-information display.

   OK: 

   "LOW ENGINE OIL LEVEL" message is displayed. 

   HINT:

   If the warning message is not displayed, go to the PROBLEM SYMPTOMS TABLE  .

1. Engine switch off.
2. Press the "DISP" button and hold it down.
3. Engine switch on (IG).
   Fig 1: Display - Multi-Information

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   OK: 

   All the dots in the multi-information display come on. 

   HINT:

   This test is also available on DATA LIST / ACTIVE TEST  .

4. Engine switch off to finish this test mode.

HINT:

If the result is not as specified, replace the combination meter assembly.