Curtain Shield Air Bag ASSY LH: Replacement
WARNING: This page is about a different car, the 2005 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
HINT:
Replacement procedure of the RH side is the same as that of the LH side except for step 8.
- (See PRECAUTION )
- DISCONNECT BATTERY NEGATIVE TERMINAL (See SUPPLEMENTAL RESTRAINT SYSTEM )
- PLACE FRONT WHEELS FACING STRAIGHT AHEAD
- REMOVE HORN BUTTON ASSY (See REPLACEMENT )
- REMOVE STEERING WHEEL ASSY (See OVERHAUL )
- REMOVE INSTRUMENT PANEL SUB-ASSY W/PASSENGER AIRBAG ASSY (See REPLACEMENT )
- REMOVE ROOF HEADLINING ASSY (See REPLACEMENT )
- REMOVE POWER BACK DOOR UNIT ASSY
- Remove the 3 bolts and the power back door unit assy.
HINT:
When replacing the RH side follow the procedure below. Remove the air duct rear No. 6.
- REMOVE CURTAIN SHIELD AIR BAG ASSY LH
- Disconnect the connector of the curtain shield airbag assy LH.
- Remove the clip, 13 bolts and the curtain shield airbag assy LH in the order shown.
- INSTALL CURTAIN SHIELD AIR BAG ASSY LH
- Install the curtain shield airbag assy LH with the 13 bolts and clip in the order shown.
Torque: 14 N.m (143 kgf.cm, 10 ft.lbf)
- Connect the curtain shield airbag assy LH connector.
- Install the curtain shield airbag assy LH with the 13 bolts and clip in the order shown.
- INSPECT CURTAIN SHIELD AIR BAG ASSY LH (See ON-VEHICLE INSPECTION )
- INSTALL INSTRUMENT PANEL SUB-ASSY W/PASSENGER AIRBAG ASSY (See REPLACEMENT )
- INSTALL POWER BACK DOOR UNIT ASSY
- INSTALL ROOF HEADLINING ASSY (See REPLACEMENT )
- INSTALL SPIRAL CABLE SUB-ASSY )
- CENTER SPIRAL CABLE (See SPIRAL CABLE SUB-ASSY )
- INSTALL STEERING WHEEL ASSY (See OVERHAUL )
- INSPECT STEERING WHEEL CENTER POINT
- INSTALL HORN BUTTON ASSY (See REPLACEMENT )
- INSPECT HORN BUTTON ASSY (See ON-VEHICLE INSPECTION )
- INSPECT SRS WARNING LIGHT (See DIAGNOSIS SYSTEM )