VSV For Vapor Pressure Sensor: Inspection

REMOVE VSV
INSPECT VSV
1. Inspect the VSV for open circuit.
  Using an ohmmeter, check that there is continuity between the terminals.
  
  Resistance: 37 - 44 Ωat 20°C (68°F)
  
  If there is no continuity, replace the VSV.
  
  Fig 1: Checking Continuity Between Terminals Using Ohmmeter
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Inspect the VSV for ground.
  Using an ohmmeter, check that there is no continuity between each terminal and the body.
  
  If there is continuity, replace the VSV.
  
  Fig 2: Checking Continuity Between Each Terminal And Body Using Ohmmeter
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Inspect the VSV operation.
  1. Check that air flows from ports E to F.
    
    Fig 3: Checking Air Flow From Ports E To F
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. Apply battery positive voltage across the terminals.
  3. Check that air flows from ports E to F.
  If operation is not as specified, replace the VSV.
REINSTALL VSV