Roof Drip Side Finish Center Moulding (Wagon): Installation

1. Remove the adhesive tape that remains on the moulding surface of the body, and then clean the surface with white gasoline.
2. Heat up the moulding and its installation surfaces on the body with a heat light.
   1. Body: 40-60°C (104-140°F) 
   2. Moulding: 20-30°C (68-86°F) 
   NOTE: Do not heat the moulding excessively.
3. Set the supplied clips into the positions as shown in the illustration, and press-fit those clips by hand to install them.
4. The installation of the moulding should be carried out 30 minutes or more after press-fitting the clips.

HINT:

• Initial hardening time: 30 minutes
• Perfect hardening time: 24 hours