Inspection Procedure

1. CHECK TERMINAL VOLTAGE (STEERING ANGLE SENSOR CONNECTOR) 
Fig 1: Checking Terminal Voltage Of Steering Angle Sensor Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the steering wheel and the column lower cover.
2. Disconnect the steering angle sensor connector S10.
3. Turn the ignition switch to the ON position.
4. Measure the voltage according to the value(s) in Fig 2 .

   Standard: 

   Fig 2: Voltage Standard Table (1 Of 2)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Measure the voltage according to the value(s) in Fig 3 .

Standard: 

Fig 3: Voltage Standard Table (2 Of 2)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: REPLACE STEERING ANGLE SENSOR (See  STEERING SENSOR  )