LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2004 >> RX 330 AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 365 (Brakes - Abs With EBD & BA & TRAC & VSC (Diagnostics)) >> Abs With EBD & BA & TRAC & VSC System >> TC Terminal Circuit >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2005 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT DLC3 TERMINAL VOLTAGE (TC TERMINAL) 
    1. Turn the ignition switch ON.
    2. Measure the voltage between terminals TC and CG of the DLC3.

      OK: 10 to 14 V 

    Fig 1: Identifying Connector Terminal Of TS & CG
    G02629296Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. NG: Go to step   4 
    2. OK: Go to next step 
  2. CHECK HARNESS AND CONNECTOR (DLC3 - ECM) 
    1. Check for an open or short circuit in harness and connector between terminal TC of the ECM and DLC3 (See ELECTRONIC CIRCUIT INSPECTION PROCEDURE ).
    1. NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 
    2. OK: Go to next step 
  3. CHECK HARNESS AND CONNECTOR (BODY GROUND - DLC3) 
    1. Check for an open circuit in harness and connector between terminal CG of the DLC3 and body ground (See ELECTRONIC CIRCUIT INSPECTION PROCEDURE ).
    1. NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 
    2. OK: Go to next step 
  4. CHECK HARNESS AND CONNECTOR (ECM - SKID CONTROL ECU) 
    1. Check for an open or short circuit in harness and connector between terminal ENG+ and ENG- of the skid control ECU and terminal ENG+ and ENG- of the ECM (See ELECTRONIC CIRCUIT INSPECTION PROCEDURE ).
    1. NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 
    2. OK: REPLACE ABS & TRACTION ACTUATOR ASSY (See  REPLACEMENT  ) 
scientia non olet · About LEMON Manuals