Inspection Procedure

WARNING: This page is about a different car, the 2005 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Start the inspection from step 1 if you are using the hand-held tester and start from step 2 if you are not using the hand-held tester.

PERFORM ACTIVE TEST BY HAND-HELD TESTER (ABS WARNING LIGHT)
1. Connect the hand-held tester to the DLC3.
2. Start the engine.
3. Select the item "ABS WARN LIGHT" in the ACTIVE TEST and operate the ABS warning light on the hand-held tester.
4. Check that "ON" of the ABS warning light is shown on the combination meter by the hand-held tester.
1. OK: REPLACE ABS & TRACTION ACTUATOR ASSY (See REPLACEMENT )
2. NG: GO TO NEXT STEP
INSPECT ABS WARNING LIGHT (See COMBINATION METER )
1. NG: REPAIR OR REPLACE COMBINATION METER ASSY
2. OK: GO TO NEXT STEP
CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER)
1. Check for an open or short circuit in harness and connector between the combination meter and skid control ECU (See ELECTRONIC CIRCUIT INSPECTION PROCEDURE ).
1. NG: REPAIR OR REPLACE HARNESS AND CONNECTOR
2. OK: REPLACE ABS & TRACTION ACTUATOR ASSY (See REPLACEMENT )