Inspection Procedure: Notes

INSPECT DLC3 TERMINAL VOLTAGE(Ts TERMINAL)

Fig 1: Inspecting DLC3 Terminal Voltage (TS Terminal)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Turn the ignition switch ON.
2. Measure voltage between terminals TS and CG of DLC3.
OK:

Voltage: 10 - 14 V
1. OK: Go to step 3
2. NG: GO TO NEXT STEP.
CHECK HARNESS AND CONNECTOR (DLC3 - SKID CONTROL ECU)
1. Check for open and short circuit in harness and connector between terminal TS of the DLC3 and skid control ECU (See ELECTRONIC CIRCUIT INSPECTION PROCEDURE ).
1. NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
2. OK: GO TO NEXT STEP.
INSPECT ABS AND VSC WARNING LIGHT

Fig 2: Connecting Terminals TS & CG Of DLC3
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Using SST, connect the terminals TS and CG of the DLC3. SST 09843-18040
2. Turn the ignition switch ON.
3. Check the ABS and VSC warning right.
OK:

Warning light blinking
1. OK: NO PROBLEM
2. NG: GO TO NEXT STEP.
CHECK AND REPLACE SKID CONTROL ECU ASSY