LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2003 >> RX 300 AWD >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Brakes Mechanical >> Removal & Installation >> Master Cylinder >> Removal

Master Cylinder: Removal

  1. Remove air cleaner assembly and drain brake fluid. See Fig 1.
  2. Disconnect brake fluid level warning switch wiring harness connector.
  3. Make a paint line on hoses pointing forward. Using pliers, slide clip and disconnect brake hose from reservoir. Remove clip.
  4. Remove bolt and disconnect reservoir assembly from bracket.
  5. Using pliers, slide clips in direction of reservoir.
  6. Make a paint line on hoses pointing forward. Disconnect reservoir hoses from master cylinder and remove clips.
  7. Using special tool (09751-36011), disconnect brake lines.
  8. Remove nuts and bracket and pull out master cylinder and gasket.
  9. Remove reservoir with 2 reservoir hoses.
Fig 1: Identifying Brake Master Cylinder Components
G00185213Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals