LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2003 >> RX 300 AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats >> Rear Seat (LH) >> Installation >> Install Rear Seat

Install Rear Seat

  1. Slide the rear seat to the frontmost position.
    NOTE: Make sure that seat adjuster locks.
  2. Without holding the seat track handle, mount the seat to the vehicle.

    HINT:

    If holding the seat track handle, the adjusted frontmost positions slip off.

  3. Tighten the bolts on the rear side temporarily, from the bolt on the inner side tighten them completely.

    Torque: 37 N.m (375 kgf.cm, 27 ft.lbf) 

  4. Slide the seat to the rearmost position to install the bolts on the front side.

    Torque: 37 N.m (375 kgf.cm, 27 ft.lbf) 

  5. Install the seat track covers.
  6. Install the 3 clips.
    Fig 1: Installing 3 Clips
    G03382221Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. Install the front part of the deck board assembly.
    Fig 2: Installing Front Part Of Deck Board Assembly
    G03382222Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals