Adjust Headlight Aim Only
- Put the vehicle below conditions.
- Make sure the body around the headlight is not deformed.
- Park the vehicle on a level spot.
- The driver gets into the driver's seat and puts the vehicle in a state ready for driving (with a full tank).
- Bounce the vehicle several times.
- Tire inflation pressure is the specified value.
- Prepare the thick white colored paper.
- Stand the paper perpendicularly and ensure the distance from it to the head lights is 9.84 ft.
- Ensure that the center line of vehicle and the paper are at a 90 degree angle as shown in the illustration (H line).
- Draw a horizontal line on the paper where the head lights (low beam center mark) of the vehicle are to be.
- Draw a vertical line on the paper where the center line of the vehicle is to be (V center line).
- Draw the vertical lines on the paper where the headlights (low beam center marks) of the vehicle are to be (V RH and LH lines).
- Turn the headlights ON.
- Check that the head lights light up the paper as shown in the illustration.
HINT:
As shown in the illustration, adjust aiming of the LH and RH lights respectively.
- Halogen Bulb Type:
Using screwdriver, adjust the headlight in the vertical direction.
- HID Type:
Adjust the headlight in the vertical direction.
- Turn the vertical movement adjusting bolt A in either direction. At this time, keep the turning direction and number of turns in mind.
- Turn the vertical movement adjusting bolt B the same number of turns and in the same direction at step (1).