Power Window Master Switch Circuit

Disconnect the connectors from the switch and inspect the connector on the wiring harness side. See CONNECTOR IDENTIFICATION . See INSPECTING POWER WINDOW MASTER SWITCH CIRCUIT table. If the circuit is not as specified, replace the switch. See step 2 of DOOR TRIM PANEL (FRONT) under REMOVAL & INSTALLATION.

INSPECTING POWER WINDOW MASTER SWITCH CIRCUIT

Tester Connection	Condition	Specified Condition
9 - Ground	Constant	Continuity
1, 5 - Ground	Constant	B+ Voltage
2, 4 - Ground	Ignition Switch LOCK	No Voltage
2, 4 - Ground	Ignition Switch ACC Or ON	B+ Voltage
15 - Ground (Left-Hand Drive)	Driver's Door Key Lock & Unlock Switch LOCK	No Continuity
15 - Ground (Left-Hand Drive)	Driver's Door Key Lock & Unlock Switch UNLOCK	Continuity
16 - Ground	Each Door Courtesy Switch ON (Door Opened)	No Continuity
16 - Ground	Each Door Courtesy Switch OFF (Door Closed)	Continuity
6 - Ground (Right-Hand Drive)	Driver's Door Key Lock & Unlock Switch LOCK	No Continuity
6 - Ground (Right-Hand Drive)	Driver's Door Key Lock & Unlock Switch UNLOCK	Continuity

Inspect the power window master switch circuit. See POWER WINDOW MASTER SWITCH CIRCUIT under CIRCUIT TESTS under BODY CONTROL SYSTEM article under COMMUNICATION DEVICES in ACCESSORIES & EQUIPMENT.