Stop Lamp System: Inspection
- INSPECT STOP LIGHT SWITCH CONTINUITY SWITCH POSITION SPECIFIED CONDITION
Switch position Tester connection Specified condition Switch pin pushed in (Pedal released) 1 - 2 Continuity Switch pin free (Pedal depressed) 1 - 2 No continuity Switch pin free (Pedal depressed) 3 - 4 Continuity Switch pin pushed in (Pedal released) 3 - 4 No continuity If continuity is not as specified, replace the switch.
- w/ Spoiler: INSPECT HI-MOUNTED STOP LIGHT ASSEMBLY CONTINUITY
Using the ohmmeter, check that continuity exists between terminals.
If continuity is not as specified, replace the bulb or light assembly.
- INSPECT STOP LIGHT SWITCH CIRCUIT (See page DI-688)
Disconnect the connector from the switch and inspect the connector on the wire harness side, as shown.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
TESTER CONNECTION SPECIFIED CONDITIONTester connection Condition Specified condition 2 - Ground Always Battery Positive Voltage If circuit is not as specified, inspect the power source or wire harness.