Garage Door Opener System: Inspection

Press the switch and check that each LED (red) lights up. Even if only one switch is found not to light up, replace it.

Fig 1: Inspecting Garage Door Opener

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

Use the home link tester made by KENT MORE for this test. As it is necessary to record the code of the hand held transmitter, customer's code will be erased. When the inspection completes, please register the customer's again.

1. Check that the code of hand held transmitter for inspection can be recorded.

   (See REGISTRATION PROCEDURE )

   If the code can not be registered, replace garage door opener.

   Fig 2: Inspecting Garage Door Opener Registration And Transmitting

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Press the switch which an inspection code has been registered for and check that LED (green) of the home link tester lights up.

   If the LED (green) does not light up, replace the garage door opener.

   Fig 3: Checking LED (Green) Of Home Link Tester Lights Up

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Disconnect the connector from the switch and inspect the connector on the wire harness side, as shown.

Fig 4: Identifying Connector Terminal

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

If the circuit is not as specified, inspect the circuits connected to other parts.