Circuit Description
When "UP" side of the height control switch is pressed, a signal is sent from terminal RC of the suspension control ECU to the AIR SUS relay to turn it on.
As a result, the current flows to the AIR SUS relay coil, closing the relay contact, and then the battery positive voltage is applied to the compressor, which causes the compressed air to raise the vehicle height.
DTC
| DTC No. | DTC Detecting Condition | Trouble Area |
|---|---|---|
| C1741/41 | Either the condition 1. or 2. is detected.
|
|
HINT:
Once ECU stores DTC C1741/41 in the memory, the vehicle height control is suspended until a normal signal is input to ECU from the AIR SUS relay. However, the control resumes if the ignition switch is once turned OFF, and then turned ON again.