Fuel Sender Gauge
- Fuel Main Sender Gauge Resistance Inspection -
Measure the resistance between terminal Nos. 1 and 2 for each float position. See Fig 1. See INSPECTING FUEL MAIN SENDER GAUGE RESISTANCE table. If the resistance value is not as specified, replace the main sender gauge. See FUEL PUMP under FUEL SYSTEM under REMOVAL & INSTALLATION
article in ENGINE PERFORMANCE.INSPECTING FUEL MAIN SENDER GAUGE RESISTANCE
Float Position mm (in.) Resistance (Ohms) F: Approx. 31.6-37.6 (1.24-1.48) Approx. 1-3 1/2: Approx. 49.4-55.4 (1.94-2.18) Approx. 23.1-29.1 E: Approx. 131.9-137.9 (5.19-5.43) Approx. 47.7-49.7 - Fuel Sub Sender Gauge Resistance Inspection -
Measure the resistance between terminal Nos. 1 and 2 for each float position. See Fig 2. See INSPECTING FUEL SUB SENDER GAUGE RESISTANCE table. If the resistance value is not as specified, replace the sub sender gauge. See FUEL PUMP under FUEL SYSTEM under REMOVAL & INSTALLATION
article in ENGINE PERFORMANCE.INSPECTING FUEL SUB SENDER GAUGE RESISTANCE
Float Position in. (mm) Resistance (Ohms) F: Approx. 0.25-0.49 (6.5-12.5) Approx. 1-3 1/2: Approx. 4.23-4.47 (107.5-113.5) Approx. 30-36 E: Approx. 8.01-8.25 (203.5-209.5) Approx. 60.3-62.3