LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2003 >> GS 430 >> Repair and Diagnosis >> Electrical >> Gauges >> Instrument Panel - Troubleshooting >> Circuit Tests >> Tachometer Circuit

Tachometer Circuit

NOTE: If not using the hand-held tester, begin with step  2.
  1. Perform the active test. Connect the hand-held tester to DLC3. See Figure. Turn the ignition switch ON and hand-held tester main switch ON. Select the ACTIVE TEST mode on the hand-held tester. Check that the probe moves as the hand-held tester directs each range. If the probe operates normally, go to IGNITOR SIGNAL CIRCUIT . If the probe does not operate normally, go to the next step.
  2. Check the tachometer. See TACHOMETER  under COMPONENT TESTS. If the results are OK, go to the next step. If the results are not good, replace the tachometer. See COMBINATION METER  under REMOVAL & INSTALLATION.
  3. Check the circuit plate. See COMBINATION METER CIRCUIT PLATE . If the results are OK, check and replace the combination meter. See COMBINATION METER CIRCUIT . If the results are not good, replace the circuit plate. See COMBINATION METER  under REMOVAL & INSTALLATION.
scientia non olet · About LEMON Manuals