Inspection Procedure

INSPECT FUSE(GAUGE1, ECU-ACC)
1. Check the continuity in GAUGE 1 fuse.
2. Check the continuity in ECU-ACC fuse.
1. NG: REPLACE FUSE
2. OK: Go to next step.

CHECK CLOCK ASSY

Check voltage.

Disconnect the connector from clock assy.
Measure voltage between each terminals of clock assy and body ground at each condition as shown in the chart.

Standard:

CLOCK ASSY TERMINALS VOLTAGE CONDITION

Terminal	Condition	Voltage (V)
1 <==> Body ground	Constant	10 - 14
4 <==> Body ground	Ignition switch ACC	10 - 14

Fig 1: Identifying Clock Assy Terminals

Check continuity.
1. Check the continuity in between terminal 2 of clock assy and body ground.
  Standard: Continuity exists.