Inspection Procedure
- INSPECT LUGGAGE DOOR DRIVE GEAR ASSEMBLY RH (LUGGAGE DOOR DRIVE MOTOR OPERATION)
- Remove the luggage door drive gear assembly RH. See OVERHAUL
.
- Connect the positive (+) lead from the battery to terminal 1 and the negative (-) lead to terminal 3, and check that the motor tuns clockwise.
- Reverse the polarity, check that the motor turns counterclockwise.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
- NG: REPLACE LUGGAGE DOOR DRIVE GEAR ASSEMBLY RH
- OK: GO TO NEXT STEP.
- CHECK HARNESS AND CONNECTOR (LMR+ AND LMR- OF SLIDING ROOF CONTROL ECU ASSEMBLY - LUGGAGE DOOR DRIVE MOTOR RH)
- NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
- OK: REPLACE SLIDING ROOF CONTROL ECU ASSEMBLY