Tilt Up Operation

When the moon roof control switch is pressed to TILT UP position (the limit switch No. 1 is off and limit switch No. 2 is on), the signal is input from terminal No. 5 of the moon roof control switch to terminal No. 5 of the moon roof control ECU. This activates the relay and rotates the motor to automatically tilt up the moon roof. If the pulse signal sent from the HALL IC is not input when the moon roof is fully tilted up, the relay determines that the motor has stopped, and stops the current flowing into the motor.

If other operation switch or tilt up switch is operated while the moon roof is being tilted up, the relay is activated to stop the moon roof operation. Additionally, when the moon roof is open, the tilt up operation does not function.