Tilt Down Operation

When the moon roof control switch is pressed to TILT DOWN position (the limit switch No. 1 is on and limit switch No. 2 is on), the signal is input from terminal No. 2 of the moon roof control switch to terminal No. 6 of the moon roof control ECU. This activates the relay and rotates the motor to automatically tilt down the moon roof. When the limit switch No. 1 is turned off, the pulse signal sent from the HALL IC activates the relay, and it determines that the moon roof is fully closed, and stops the motor rotation.

If other operation switch or tilt down switch is operated while the moon roof is being tilted down, the relay is activated to stop the moon roof operation.