Combination Meter ECU Circuit
Remove instrument cluster. See INSTRUMENT CLUSTER under REMOVAL & INSTALLATION. Using DVOM, check for continuity between appropriate instrument cluster connector terminals. See Figure. Ensure continuity is as specified. See COMBINATION METER ECU CIRCUIT VALUES table. If continuity is not as specified, check and replace appropriate bulb as necessary. If bulb is okay, replace instrument cluster.
COMBINATION METER ECU CIRCUIT VALUES
| Tester Connection | Indicator/Warning Light | Circuit Value |
|---|---|---|
| F1 & E11, E12, E13 | Right Turn | Continuity |
| F2 & E11, E12, E13 | Left Turn | Continuity |
| F3 & E3, E4 | SLIP | Continuity |
| F4 & E3, E4 | TRAC OFF | Continuity |
| F5 & E3, E4 | CRUISE MAIN | Continuity |
| F6 & E3, E4 | MIL | Continuity |
| F7 & E3, E4 | ABS | Continuity |
| F8 & F10 | HI-Beam | Continuity |
| F9 & F14 | SRS | Continuity |
| F12 & E3, E4 | O/D OFF | Continuity |
| F13 & E3, E4 | Washer Level | Continuity |