Speedometer Circuit
NOTE:
If Lexus hand-held tester is not available, begin testing with step 2).
- Connect Lexus hand-held tester to Data Link Connector No. 3 (DLC3). With tester in ACTIVE TEST mode, operate speedometer. If speedometer needle moves as commanded by tester, replace A/C and combination meter integrated ECU. See Figure. If speedometer needle does not move as commanded by tester, check for ABS DTCs. See appropriate ANTI-LOCK - RX300 article in BRAKES. If any DTCs from DTC 31 to DTC 35 are set, repair as necessary. If no DTCs are set, go to next step.
- Check for open or short in harness or connector between A/C and combination meter integrated ECU and ABS ECU. Repair as necessary. If circuits are okay, go to next step.
- Check speedometer. See SPEEDOMETER under COMPONENT TESTS. Repair as necessary. If speedometer is okay, replace combination meter circuit plate. See Figure.