Rear Door (Luggage Compartment)
- Disconnect 2-pin harness connector from rear door lock motor assembly. Using DVOM, measure voltage between ground and terminal No. 1 (White/Black wire) at vehicle side of harness connector. Ensure battery voltage is present with luggage compartment door opener switch in ON position, and no voltage is present with switch in OFF position. Go to next step.
- Measure voltage between ground and terminal No. 2 (White/Red wire) at vehicle side of harness connector. Ensure battery voltage is present at all times. If voltage is not as specified, check power source or circuit. See WIRING DIAGRAMS . Repair as necessary.