Fuel Gauge Circuit
NOTE:
If Lexus hand-held tester is not available, begin testing with step 2).
- Connect Lexus hand-held tester to Data Link Connector No. 3 (DLC3). With tester in ACTIVE TEST mode, operate fuel gauge. If fuel gauge needle moves as commanded by tester, perform next check listed in appropriate symptom diagnosis table. See TROUBLE SHOOTING . If fuel gauge needle does not move as commanded by tester, go to next step.
- Check fuel gauge. See FUEL GAUGE under COMPONENT TESTS. Repair as necessary. If fuel gauge is okay, go to next step.
- Check fuel gauge sending units. See FUEL GAUGE under COMPONENT TESTS. Repair as necessary. If fuel gauge sending unit is okay, go to next step.
- Check combination meter 22-pin connector at circuit plate. See Figure. See INSTRUMENT CLUSTER CIRCUIT PLATE under COMPONENT TESTS. Repair as necessary. If voltages are to specification, replace instrument cluster.