Twin Trip & Odometer Switch
Disconnect 3-pin electrical connector from twin trip and odometer (ODO) switch. Using an ohmmeter, check for continuity between specified switch terminals with switch in specified position. See Fig 1. See TWIN TRIP & ODO SWITCH CONTINUITY table. If continuity is not as specified, replace twin trip and odometer (ODO) switch.
TWIN TRIP & ODO SWITCH CONTINUITY
| Switch Position | Terminals No. | Continuity | |
|---|---|---|---|
| ODO/TRIP | |||
| Free | 1 & 2 | No | |
| Pushed | 1 & 2 | Yes | |
| RESET | |||
| Free | 2 & 3 | No | |
| Pushed | 2 & 3 | Yes | |