Combination Meter Circuit
Disconnect instrument cluster circuit plate 22-pin harness connector. See Figure. Check voltage between specified harness connector (harness side) terminal and ground. See COMBINATION METER CIRCUIT VOLTAGE CHECK table. If voltages are not to specification, replace wiring harness.
COMBINATION METER CIRCUIT VOLTAGE CHECK
| Terminal No. (1) | Condition | Voltage | ||
|---|---|---|---|---|
| 1 | Ignition On | Battery Voltage | ||
| 12 | At All Times | Battery Voltage | ||
| 13 | At All Times | Battery Voltage | ||
| 14 | Hazard Switch On | No Voltage | ||
| 15 | Hazard Switch On | No Voltage | ||
| 16 | Taillights Or Headlights On | Battery Voltage | ||
| 22 | At All Times | No Voltage | ||
|
||||