LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2000 >> SC 400 >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes >> Adjustments >> Power Brake Unit Push Rod

Power Brake Unit Push Rod

  1. Adjust power brake unit push rod length before installing new master cylinder or power brake unit. Install master cylinder gasket. Place Master/Booster Push Rod Measurer (SST 09737-00010) on gasket and lower pin until it touches master cylinder piston.
  2. Without moving pin, invert master/booster push rod measurer, and set it on power brake unit. Measure clearance between power brake unit push rod and pin. Clearance should be zero. If clearance is not zero, adjust power brake unit push rod length until push rod lightly touches pin head.
scientia non olet · About LEMON Manuals