LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2000 >> SC 400 >> Repair and Diagnosis (Single Page) >> Suspension >> Rear Suspension >> Removal & Installation >> Upper Suspension Arm >> Removal & Installation (SC400 & SC300)

Removal & Installation (SC400 & SC300)

  1. Raise and support vehicle. Remove rear wheels. Remove drive shaft. See REAR AXLE CARRIER . Remove 2 bolts and brake caliper from rear axle hub. Support brake caliper securely.
  2. Remove ABS wire harness clamp. Disconnect center exhaust pipe with tailpipe. Using Puller (09628-62011), disconnect upper suspension arm from axle carrier. Remove 2 bolts, nuts, washers and upper suspension arm.
  3. To install, reverse removal procedure. Check rear wheel alignment. Tighten bolts/nuts to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals