LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2000 >> SC 400 >> Repair and Diagnosis (Single Page) >> Suspension >> Rear Suspension >> Removal & Installation >> Upper Suspension Arm >> Removal & Installation (GS400 & GS300)

Removal & Installation (GS400 & GS300)

  1. Raise and support vehicle. Remove drive shaft. See REAR AXLE CARRIER . Remove shock absorber. See STRUT ASSEMBLY .
  2. Using Puller (09628-62011), disconnect upper suspension arm from axle carrier. Remove 2 bolts, nuts, washers and upper suspension arm. See Figure.
  3. To install, reverse removal procedure. Check ABS speed signal and rear wheel alignment. Tighten bolts/nuts to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals