Disassembly (GS300, GS400, SC300 & SC400)

1. Using a screwdriver, remove dust shield from hub assembly. See Fig 1. Secure hub assembly in vise. Using Rear Axle Shaft Puller (09520-00031) and slide hammer, remove axle hub. Remove backing plate. Using Seal Puller (09308-00010) and slide hammer, remove inner oil seal. See Figure.
2. Using puller, remove inner race. Remove outer oil seal. Remove bearing snap ring. Temporarily install inner race from axle hub inside bearing assembly. Press bearing from hub assembly.

Fig 1: Exploded View Of Hub Assembly (Typical)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002