Removal & Installation (ES300 )
- Raise and support vehicle. Remove rear wheels. Remove brake caliper and disc assembly. Suspend it using wire. Place match marks on hub and disc for reassembly reference. Measure bearing axial play. See WHEEL BEARING .
- Remove rear axle hub. Remove "O" ring. Remove ABS speed sensor. Remove fasteners and disconnect strut rod from rear axle carrier. Remove lower shock mounting. Remove No. 2 lower suspension arm. Remove rear axle carrier.
- To install, reverse removal procedure. After installation, check ABS speed sensor signal and rear wheel alignment. Tighten nuts and bolts to specification. See TORQUE SPECIFICATIONS .