Hydraulic Brake Booster: Reassembly

To install accumulator bracket, adjust clearances "A", "B", "D" and "E". Using thickness gauge, ensure clearances correspond to each value and are in "C" range. SeeFig 1 and Fig 2 . To complete reassembly, reverse disassembly procedure. After installation, fill brake reservoir with brake fluid. Bleed brake system and check for leaks. See BLEEDING BRAKE SYSTEM .

Fig 1: Adjusting Accumulator Bracket Clearances (1 Of 2)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Fig 2: Adjusting Accumulator Bracket Clearances (2 Of 2)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002