Instrument Cluster ECU-To-Telltale Light Assembly Circuits
Remove instrument cluster. See INSTRUMENT CLUSTER under REMOVAL & INSTALLATION. Disconnect connectors "G" and "U" from instrument cluster circuit plate. See Figure. Ensure continuity is present between harness connectors at specified terminals. See CIRCUIT PLATE CONNECTOR CONTINUITY table. Replace instrument cluster circuit plate if continuity is not as specified.
CIRCUIT PLATE CONNECTOR CONTINUITY
| Connector "G" Terminal No. | Connector "U" Terminal No. |
|---|---|
| 1 | 9 |
| 3 | 1 |
| 5 | 10 |
| 6 | 4 |
| 7 | 3 |
| 8 | 8 |