Rear Stabilizer Bar (G2296776): Removal

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.
The stabilizer bar bushes are bonded in place and do not separate from the bar.
Steps 3 to 5 must be completed to the components on both sides of the vehicle.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING AND LIFTING .
Remove the rear silencer.
Refer to: REAR SILENCER .
Remove the rear brake pads.
Refer to: BRAKE PADS .
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove and discard the nut.
- Reposition the stabilizer bar link.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove and discard the nut and bolt.
- Reposition the upper control arm.
Carry out steps 3 to 5 on the other side of the vehicle.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove and discard the 4 bolts.
- Remove the stabilizer bar.