LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2023 >> Range Rover Evoque SE >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System -- Range Rover EVOQUE/L551 >> Supplementary Restraint System >> Removal And Installation >> Impact Pressure Sensor (G2301157) >> Installation

Impact Pressure Sensor (G2301157): Installation

    • Install the impact pressure sensor.
    • Install and tighten the 2 screws.

      Torque  : 1.9 Nm 

    • Connect the impact pressure sensor electrical connector.
  2. Install the front door trim panel.

    Refer to: FRONT DOOR TRIM PANEL .

  3. Connect the startup battery ground cable.

    Refer to: 12V SYSTEM DISCONNECT .

scientia non olet · About LEMON Manuals