LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2023 >> Range Rover Evoque SE >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System -- Range Rover EVOQUE/L551 >> Supplementary Restraint System >> Removal And Installation >> Driver Airbag (G2301156) >> Installation

Driver Airbag (G2301156): Installation

  1. CAUTION:
    • Take extra care not to damage the wiring harnesses.
    • Driver airbag installation can be confirmed by hearing 3 audible clicks, 1 for each clip.
    • Connect the 2 electrical connectors.
    • Install the driver airbag.
  2. Connect the startup battery ground cable.

    Refer to: 12V SYSTEM DISCONNECT .

  3. If a new component has been installed, configure using Jaguar Land Rover (JLR) approved diagnostic equipment.

    General Equipment: Jaguar Land Rover approved diagnostic equipment