LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2023 >> Range Rover Evoque SE >> Repair and Diagnosis >> Engine Mechanical >> Fuel System >> Fuel Charging And Controls - INGENIUM I4 2.0L Petrol -- Range Rover EVOQUE/L551 >> Fuel Charging And Controls - INGENIUM I4 2.0L Petrol >> Removal And Installation >> Fuel Pump Driver Module (G2797713) >> Installation

Fuel Pump Driver Module (G2797713): Installation

    • Install the FPDM  .
    • Install and tighten the 2 nuts.

      Torque  : 5 Nm 

  2. Connect the electrical connector.
  3. Install the rear right wheel arch liner.

    Refer to: REAR WHEEL ARCH LINER .

  4. Connect the 12 V system.

    Refer to: 12V SYSTEM DISCONNECT .

scientia non olet · About LEMON Manuals