Rear Differential Control Module (G2309516): Installation
-
- Install the Rear Drive Unit (RDU) control module.
- Install the 2 upper bolts finger tight.
- Install the 2 lower bolts finger tight.
- Fully tighten the 2 lower bolts.
Torque : 10 Nm
- Fully tighten the 2 upper bolts.
Torque : 10 Nm
- Connect the 2 RDU control module electrical connectors.
- Install the wiring harness clip.
- If a new component has been installed, configure using the Jaguar Land Rover (JLR) approved diagnostic equipment.
General Equipment: Jaguar Land Rover approved diagnostic equipment