LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2023 >> Range Rover Evoque SE >> Repair and Diagnosis >> Accessories & Equipment >> Warning Systems >> Parking Aid -- Range Rover EVOQUE/L551 >> Parking Aid (G1665841) >> Removal And Installation >> Parking Aid Module (G2309450) >> Installation

Parking Aid Module (G2309450): Installation

    • Install the parking aid module.
    • Connect the 2 electrical connectors.
    • Install the 2 nuts.

      Torque  : 2.2 Nm 

  2. Install the right loadspace side trim panel.

    Refer to: RIGHT LOADSPACE SIDE TRIM PANEL .

  3. Connect the startup battery ground cable.

    Refer to: 12V SYSTEM DISCONNECT .

  4. NOTE:
    • This step is only required if a new component is installed.
    • SRO to be claimed separately.
    • Use the Jaguar Land Rover (JLR) approved diagnostic equipment to configure the new module.

      General Equipment: Jaguar Land Rover approved diagnostic equipment 

    • Follow all on-screen instructions to complete this task.
scientia non olet · About LEMON Manuals