Pinpoint Test E: Front Seat Tilt And/Or Seat Extension Motor Movement Not Functioning

E1: CHECK FRONT SEAT TILT OR EXTENSION MOTOR

WARNING:

Before work is completed, make the airbag supplemental restraint system safe. For additional information, refer to Standard Workshop Practices article.
When carrying out the following steps, stand clear of all moving parts and make sure link harness is routed accordingly.

Set ignition status to ' OFF'.
Disconnect front seat tilt or extension motor connector.
NOTE: It may be that the seat has been driven to the limit of travel along the relevant axis, and when the link harness is connected, the seat will remain in the same position. If this is the case, a jolt may be felt from the motor. To confirm the motor operation, swap the link harness to alternate motor pin connections and the seat should travel in the opposite direction.

Using a locally made fused link harness and power supply, connect power and ground to relevant motor.

BATTERY POSITIVE TERMINAL	BATTERY NEGATIVE TERMINAL
motor pin 1	motor pin 2

Does the motor operate?

Yes: Using the Jaguar Land Rover approved diagnostic equipment, check for related Diagnostic Trouble Code(s) and complete the repair operations specified. Alternatively, refer to the electrical circuit diagrams and check relevant motor circuits.

No: Replace the relevant motor. Refer to relevant article.