Rear Suspension (G1950132): Specifications
TORQUE SPECIFICATIONS
| DESCRIPTION | NM | LB-FT |
|---|---|---|
| Shock absorber to knuckle bolt ++ | ||
| Stage 1 | 100 | 66 |
| Stage 2 | Then a further 240 degrees | Then a further 240 degrees |
| Shock absorber top nut | 27 | 20 |
| Shock absorber mounting nuts + | 48 | 35 |
| Upper control arm to subframe bolt | ||
| Stage 1 | 50 | 37 |
| Stage 2 | Then a further 60 degrees | Then a further 60 degrees |
| Upper control arm to knuckle bolt | ||
| Stage 1 | 50 | 37 |
| Stage 2 | Then a further 60 degrees | Then a further 60 degrees |
| Lower control arm to subframe front bolt ++ | ||
| Stage 1 | 100 | 74 |
| Stage 2 | Then a further 240 degrees | Then a further 240 degrees |
| Lower control arm to subframe rear bolt ++ | ||
| Stage 1 | 100 | 74 |
| Stage 2 | Then a further 240 degrees | Then a further 240 degrees |
| Lower control arm to knuckle bolt ++ | ||
| Stage 1 | 70 | 52 |
| stage 2 | Then a further 240 degrees | Then a further 240 degrees |
| Lower control arm to integral link bolt ++ | ||
| Stage 1 | 50 | 37 |
| Stage 2 | Then a further 180 degrees | Then a further 180 degrees |
| Integral link to knuckle bolt ++ | ||
| Stage 1 | 50 | 37 |
| Stage 2 | Then a further 180 degrees | Then a further 180 degrees |
| Toe link to subframe bolt | ||
| Stage 1 | 40 | 30 |
| Stage 2 | Then a further 60 degrees | Then a further 60 degrees |
| Toe link to knuckle bolt ++ | ||
| Stage 1 | 70 | 52 |
| Stage 2 | Then a further 240 degrees | Then a further 240 degrees |
| Stabilizer bar clamp nuts/bolts ++ | ||
| Stage 1 | 30 | 22 |
| Stage 2 | 84 | 62 |
| Stage 3 | 120 | 86 |
| Stabilizer link nuts | 185 | 136 |
| Dynamic response actuator clamp nuts/bolts ++ | 110 | 81 |
| Dynamic response actuator link nuts | 185 | 136 |
| Subframe to body rear bolts + | ||
| Stage 1 | 100 | 74 |
| Stage 2 | Then a further 300 degrees | Then a further 300 degrees |
| Subframe to body front bolts | 170 | 125 |
| Subframe support bracket to body bolts | 60 | 44 |
+ A new nut or bolt must be installed
++ New nut and bolt must be installed
Rear Wheel Hub Runout
| DESCRIPTION | MM |
|---|---|
| Rear wheel hub | 0.0135 mm |
Runout must be measured 2.5 mm from the outer diameter of the rear wheel hub.