Rear Stabilizer Bar - Vehicles Without: Dynamic Suspension (G2341174): Installation

The following step(s) applies to: 

All vehicles 

1. CAUTION: Nuts and bolts must be tightened with vehicle at normal ride height.
   • Install the stabilizer bar.
   • Install and tighten the 2 new nuts and bolts.

     Renew Part: Rear stabilizer bar to subframe nuts Quantity: 2. 

     Renew Part: Rear stabilizer bar to subframe bolts Quantity: 2. 

     Torque 

     Stage 1: 30 Nm 

     Stage 2: 84 Nm 

     Stage 3: 120 Nm 

2. • Install the 2 heatshields.
   • Install and tighten the 4 bolts.

     Torque  : 10 Nm 

3. CAUTION:

   • Nuts must be tightened with vehicle at normal ride height.
   • Use a wrench on the hexagon provided to prevent the ball joint rotating.
   NOTE:

   • LH illustration shown, RH is similar.
   • The step must be carried out on both sides.
   • Install the stabilizer bar.
   • Install and tighten the nut.

     Torque  : 185 Nm 

   The following step(s) applies to: 

   Vehicles with petrol engine 

4. NOTE: If equipped.
   • Install the bracket.
   • Install and tighten the 4 bolts.

     Torque  : 10 Nm 

5. NOTE: If equipped.
   • Install the cover.
   • Install and tighten the 4 nuts.
6. • With assistance, install the exhaust system.
   • Install the 2 exhaust hanger mounting rubbers.
7. Connect the electrical connector.
8. NOTE: The step must be carried out on both sides.

   Install the 2 exhaust hanger mounting rubbers.

9. Install and tighten the 2 exhaust clamps.

   Torque  : 55 Nm 

   The following step(s) applies to: 

   Vehicles with diesel engine 

10. Install the rear silencer.

    Refer to the appropriate service information

    The following step(s) applies to: 

    All vehicles 

11. Install the rear air spring.

    Refer to: REAR AIR SPRING