Exhaust System - INGENIUM I6 3.0L Petrol (G2300912): Installation

NOTE: This step is only required if previously removed.

Install the 6 exhaust hanger brackets to the exhaust system.
WARNING: This step requires the aid of another technician.
- With the aid of another technician, install the exhaust system.
- Install and tighten the 2 M8 x 35 bolts.
  Torque : 30 Nm
- Install and tighten the 8 M8 x 20 bolts.
  Torque : 27.5 Nm
- Install the front silencer clamp into the correct position and fully tighten.
  Torque : 55 Nm
- Connect the electrical connector.
- Install the wiring harness clip.