Catalytic Converter (G2328358): Installation

CAUTION: If accidentally dropped or knocked install a new sensor.

NOTE: This step is only required if previously removed.

Use the special tool to install and tighten the mid catalyst Heated Oxygen Sensor (HO2S).

Special Tool(s): JLR-309-004

Torque : 48 Nm
- Install the gasket.
  Renew Part: Catalytic converter to turbocharger gasket Quantity: 1 .
- Install the catalytic converter.
- Install the bracket.
- Install and tighten the 2 nuts.
  Torque : 25 Nm
- Install the 2 catalytic converter bolts, but do not fully tighten at this stage.
- Install and tighten the clamp.
  Renew Part: Catalytic converter to turbocharger clamp Quantity: 1 .
  
  Torque : 16 Nm
- Fully tighten the 2 catalytic converter bolts.
  Torque : 25 Nm
- Connect the electrical connector.
- Install the wiring harness into the clip.
Install the noise, vibration and harshness material into its original position.
CAUTION: If accidentally dropped or knocked install a new sensor.

Use the special tool to install and tighten the pre catalyst HO2S.

Special Tool(s): JLR-309-004

Torque : 48 Nm
- Install the heatshield.
- Install and tighten the 3 bolts.
  Torque : 9 Nm
- Connect the electrical connector.
- Install the wiring harness into the 2 clips.
- Install the pipe assembly.
- Install the 3 clips.
Install the starter motor.
Refer to: STARTER MOTOR
Install the Gasoline Particulate Filter (GPF)
Refer to: GASOLINE PARTICULATE FILTER
Connect the startup battery ground cable.
Refer to: SPECIFICATIONS