Brake System - General Information (G2380817): Specifications
Brake Fluid - All vehicles except 5.0L AJ133
WARNING:
Do not mix the specified brake fluid with any other type of brake fluid.
CAUTION:
If the below brake fluid is not available, use a low viscosity DOT 4 brake fluid meeting ISO 4925 Class 6 and Land Rover LRES22BF03 requirements.
| ITEM | SPECIFICATION |
|---|---|
| Recommended brake fluid | Land Rover approved brake fluid |
| Fluid quantity | 890 cm3 |
Brake Fluid:
Vehicles with 5.0L AJ133, Armoured, SVR or SVA
WARNING:
- Do not mix the specified brake fluid with any other type of brake fluid.
- L494 SVR vehicles from Vehicle Identification Number (VIN) LW757542 onwards, and L405 SVA vehicles from VIN LG420859 onwards, must use Clariant BrakeSafe® 10 M brake fluid.
CAUTION:
If the below brake fluid is not available, use an equivalent high performance ISO 4925 DOT 4, class 4 brake fluid with a ERBP (dry boiling point) of at least 300 deg C and a WERBP (wet boiling point) of 270 deg C.
| ITEM | SPECIFICATION |
|---|---|
| Recommended brake fluid | Castrol react SRF racing high performance brake fluid. |
| Recommended brake fluid | Clariant BrakeSafe® 10 M |
| Fluid quantity | 890 cm3 |
General Specification:
VEHICLES WITH 380 MM FRONT BRAKES - PART SPECIFICATION
| ITEM | SPECIFICATION |
|---|---|
| Footbrake type: | Hydraulic, servo assisted, self-adjusting with front/rear split hydraulic system, opposed 6 piston calipers to the front and single piston sliding calipers to the rear |
| Disc type and diameter | |
| Front - ventilated | 380 mm (14.9 in) |
| Rear - ventilated | 365 mm (14.4 in) |
| Front disc thickness: | |
| New | 34.0 mm (1.33 in) |
| Service limit | 32.0 mm (1.26 in) |
| Rear disc thickness: | |
| New | 25.0 mm (0.98 in) |
| Service limit | 23.0 mm (0.90 in) |
| Minimum pad material thickness: | |
| Front | 1.5 mm (0.06 in) |
| Rear | 3 mm (0.12 in) |
| Pad material | Asbestos free |
| Front Caliper | |
| Type | 6 piston |
| Piston diameter - 1 and 2 | 36 mm (1.41 in) |
| Piston diameter - 3 and 4 | 38 mm (1.49 in) |
| Piston diameter - 5 and 6 | 40 mm (1.57 in) |
| Rear caliper | |
| Piston diameter | 45 mm (1.77 in) |
VEHICLES WITH 363 MM FRONT BRAKES - PART SPECIFICATION
| ITEM | SPECIFICATION |
|---|---|
| Footbrake type: | Hydraulic, servo assisted, self-adjusting with front/rear split hydraulic system, opposed 4 piston calipers to the front and single piston sliding calipers to the rear |
| Disc type and diameter | |
| Front - ventilated | 363 mm (14.2 in) |
| Rear - ventilated | 350 mm (13.8 in) |
| Front disc thickness: | |
| New | 33.0 mm (1.30 in) |
| Service limit | 31.0 mm (1.22 in) |
| Rear disc thickness: | |
| New | 25 mm (0.98 in) |
| Service limit | 23.0 mm (0.90 in) |
| Minimum pad material thickness: | |
| Front | 2 mm (0.08 in) |
| Rear | 3 mm (0.12 in) |
| Pad material | Asbestos free |
| Front Caliper | |
| Type | 4 piston |
| Piston diameter | 48 mm (1.90 in) |
| Rear caliper | |
| Piston diameter | 45 mm (1.77 in) |
VEHICLES WITH 349 MM FRONT BRAKES - PART SPECIFICATION
| ITEM | SPECIFICATION |
|---|---|
| Footbrake type: | Hydraulic, servo assisted, self-adjusting with front/rear split hydraulic system, 2 piston sliding calipers to the front and single piston sliding calipers to the rear |
| Disc type and diameter | |
| Front - ventilated | 349 mm (14.2 in) |
| Rear - ventilated | 325 mm (13.8 in) |
| Front disc thickness: | |
| New | 34.0 mm (1.30 in) |
| Service limit | 32.0 mm (1.22 in) |
| Rear disc thickness: | |
| New | 25 mm (0.98 in) |
| Service limit | 23.0 mm (0.90 in) |
| Minimum pad material thickness - Front and rear: | 3 mm (0.12 in) |
| Pad material | Asbestos free |
| Front Caliper | |
| Type | 2 piston |
| Piston diameter | 48 mm (1.90 in) |
| Rear caliper | |
| Piston diameter | 45 mm (1.77 in) |