Pinpoint Test B: 2-Way Lumbar Inflate Tests

B1: 2-WAY LUMBAR INFLATE TEST 1
1. Set the ignition to on
2. Operate the seat switchpack lumbar inflate switch
3. Listen for the lumbar air pump operating
  Was the lumber air pump operation audible?
  
  Yes: GO to B2.
  
  No: GO to B3.
B2: 2-WAY LUMBAR INFLATE TEST 2
NOTE: The battery support unit must be connected during this test to ensure that the power supply is stable.
NOTE:
- Circuit reference - VBATT -
- The 2-way lumbar inflate circuit current specification is 1.05A ± 10%.
1. Connect an inductive ammeter to the seat switchpack power circuit
2. Set the ignition to on
3. Operate the seat switchpack lumbar inflate switch
  Is the measured current within specification?
  
  Yes: Check the lumbar air cell hose for leaks/blockages
  
  No: Refer to the electrical circuit diagrams and check the lumbar air pump/lumbar inflate solenoid circuit for open circuit, high resistance
B3: 2-WAY LUMBAR INFLATE TEST 3
NOTE: Do not disconnect the electrical connector during this step; the seat switchpack is removed for access to the wiring harness only.
1. Refer to the relevant service information and remove the seat switchpack
2. Set a multimeter to measure voltage
3. Using the multimeter, measure and record the battery voltage (reference voltage)
  NOTE: Circuit reference - LUMBAR PUMP/GND -
4. Connect the multimeter across the seat switchpack lumbar pump terminal and the ground terminal
5. Set the ignition to on
6. Operate the seat switchpack lumbar inflate switch
  Is the measured voltage less than battery voltage?
  
  Yes: GO to PINPOINT TEST A .
  
  No: Refer to the electrical circuit diagrams and check the lumbar air pump/lumbar inflate solenoid circuit for short circuit to ground, short circuit to power, open circuit, high resistance